In any case, it seems that the two settings should not be applied together, if they manipulate the same variable (but I have not seen this recommendation anywhere). If this is so, the question is: which setting is applied first? This seems to imply that increasing the initial layer width will automatically also increase initial layer flow. by the same factor, so it would not produce overextrusion This causes the nozzle to press the material harder on the build plate (.) Not only will the lines be wider. to make the printer push out slightly more material than it normally would.īut then there is also a setting called "Initial Layer Width" and according to the the Cura Settings Guide (see image below), increasing line width will make the nozzleĮxtrude more material and that material has to flow wider outward. The obvious way of doing that in Cura is by increasing the "Initial Layer Flow", i.e. I'm trying to increase adhesion of the first layer (as well as to fill gaps for a more even surface) by squeezing more material against the bed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |